Comments on: a rat got into my treadmill, i cleared away the nest and readjusted the wires and everything runs fine except? http://treadmill-guide.com/treadmills/a-rat-got-into-my-treadmill-i-cleared-away-the-nest-and-readjusted-the-wires-and-everything-runs-fine-except/ Getting Fit on the Road to Nowhere Fri, 02 Apr 2010 03:03:49 +0000 http://wordpress.org/?v=2.9.2 hourly 1 By: wirestrike2002 http://treadmill-guide.com/treadmills/a-rat-got-into-my-treadmill-i-cleared-away-the-nest-and-readjusted-the-wires-and-everything-runs-fine-except/comment-page-1/#comment-837 wirestrike2002 Wed, 12 Aug 2009 20:17:13 +0000 http://treadmill-guide.com/treadmills/a-rat-got-into-my-treadmill-i-cleared-away-the-nest-and-readjusted-the-wires-and-everything-runs-fine-except/#comment-837 I'm sure you already checked the wiring harness that goes from the console to the power board(not the motor control board) There should be a tech sheet under the hood, it will have instructions on what light indicates you are getting a signal from the console, check it. If the light is working, calibrate the incline motor and try it again. If that doesn't work, check the wiring harness on both ends and check the connections between the power board and the incline motor. if that doesn't work, you may need a new power board or a new console. Send me a messsage if you need a little help. I’m sure you already checked the wiring harness that goes from the console to the power board(not the motor control board) There should be a tech sheet under the hood, it will have instructions on what light indicates you are getting a signal from the console, check it. If the light is working, calibrate the incline motor and try it again. If that doesn’t work, check the wiring harness on both ends and check the connections between the power board and the incline motor. if that doesn’t work, you may need a new power board or a new console.

Send me a messsage if you need a little help.

]]> By: vortex http://treadmill-guide.com/treadmills/a-rat-got-into-my-treadmill-i-cleared-away-the-nest-and-readjusted-the-wires-and-everything-runs-fine-except/comment-page-1/#comment-836 vortex Wed, 12 Aug 2009 08:12:12 +0000 http://treadmill-guide.com/treadmills/a-rat-got-into-my-treadmill-i-cleared-away-the-nest-and-readjusted-the-wires-and-everything-runs-fine-except/#comment-836 rats like to chew on wires check the entire wire harness for chewed up wires rats like to chew on wires check the entire wire harness for chewed up wires

]]>